All contents copyright ©, Drive and Stay Alive, Inc., 2003 onwards, unless specified otherwise. All rights reserved. IMPORTANT: click here to read the DISCLAIMER |
|||||||||
|
February 13-19, 2005, is
Remember to Correctly Install/Use Your Child's Car Seat
February 13, 2005
By: Jeff Ogden, president of AAA Minnesota/Iowa
|
|||||||||
|
Millions of parents who regularly check their engine fluids and tire pressure should add one more thing to the checklist: child safety seats. Fewer than one in six child seats are installed and used correctly, according to data from AAA.
First, make sure the safety seat is installed tightly. Grab the child seat where the seat belt threads through it and pull. It should not lift up more than one inch or move more than one inch from side to side. If it does, it is not tight enough.
Second, be certain the harness straps are pulled tight to the child. The harness should be snug and lie flat on the child so that no slack can be pinched in the straps.
Third, position the retainer clip at the child's armpit level when the harness is snug. An improperly positioned retainer clip causes the harness straps to fit incorrectly.
Fourth, if a locking clip is needed, check that it is in the right place and is threaded correctly. Child safety seat manuals and car owner's manuals give specific information about using locking clips.
Fifth, make sure the harness straps are not twisted and are routed through the appropriate slots for the direction that the seat is facing. Rear-facing seats should have the straps at or below the child's shoulders; forward-facing seats should have the straps at or above the child's shoulders.
By
correcting these five common mistakes, families can gain peace of mind
by increasing the safety of their young children.
Source: AAA Minnesota/Iowa
|
|||||||||
|
|
|||||||||
|
|